Info Pei
4. Straighten inside of side member. Check installed position with a water level. 5. Install and spot weld impact absorber mount. Also tack weld with arc welder. 4. Fit wheel house wait, cut mating surface with an overlap and install. Check lateral position with a water level applied at opening for headlight shaft. Spot weld wheel house and arc weld vertical seam on outside. 5. Install and spot weld impact absorber mount. Also tack weld with arc welder. 3. Pull or grind off scrap metal....
Body Paint Colors Beginning With 1991 Models
Water base paints are applied exclusively by the manufacturer during production spraying. For repair of watwer-base paints, conventional respray paints matching the color of the original paint are used. I.e. the only prerequisite for resprays is that the correct respray paint is used refer to Paint Manual, page L3 - 25 . Color differences due to paint application do no occur.
Instructions Odq
4 - Decorative frame part, bottom Carefully release the decorative frame from the rubber seal in the area of the top corner piece using a wooden or plastic spatula. Insert fabric cloths between the decorative frame and rubber seal and pull out the decorative frame by pulling the fabric cloth along the rubber seal. Equip the cutting device A with the curved knife E . Sharpen the cutting knife with a whetting stone when the machine is running. Insert the cutting knife in the rubber seal, set the...
Workshop Manual
DR. ING. h. c. F. PORSCHE Aktiengesellschaft Template for rear side parts to PU trim - 9172 Template for rear window opening - 9159 Template for windshield opening - 9158 Inert gas welder for steel and galvanized metal Inert gas welder for aluminum parts Gas welder Pneumatic gun with attachments, chisel etc. Hydraulic 10 ton straightener with accessories Pneumatic guns, equipment and materials for longterm undercoating for cavity sealing for sealing jobs Set of Attachements ENS 243.300 for...
Removing and Installing the bonded rear side window
materials are required for removal and Installation of the bonded rear side windows
Info Meb
REPLACING LATCH ON REAR LID LOCK UPPER SECTION If the edge of the plastic latch in lock upper section is worn and this is impairing the lock's function, the latch of an installed lock upper section can be replaced. 2, Remove plastic latch, making sure that the spring behind is not lost. 1. Drive rivet pin out of housing from the riveted side with a 3 to 4 mm dia. punch. Counter-hold the opposite side 3. Install new latch with spring, pushing in the spring with a small screwdriver until the...