Front Axle
Adjust camber by turning eccentric bolt arrow . Adjust caster by moving the rear of suspension control arm from side to side. Center steering gear with special tool 9116 and adjust toe at tie rods. Steering difference angle cannot be adjusted. It can only be affected by replacing steering arm. REAR AXLE upto 1978 Models Adjusting Camber Rear wheel toe can be adjusted by moving trailing arm within slots with respect to torsion plate. Adjust toe angle using special tool US 4437 A. When tightening...
Disassembling And Assembling Parking Brake Lever
Loosen mounting screws and take out entire parking brake lever. Apply a multi-purpose grease to all sliding and bearing surfaces. Install parking brake lever and check operation of contact switch. It must respond before the first catch. Adjust by bending holder if necessary. 1. Adjust service brake see page 46-11 . 2. Pull parking brake lever by two teeth. 3. Tighten adjusting nut until both wheels can just barely be turned by hand. 4. Release parking brake lever and check whether both wheels...
Info Jne
- vacuum hose layout 87-2 Air flow sensor operating lever 25 - 17 Air injection check valve 26-5 Air pump 26-4 - V-belt 26 - 4 Alternator V-belt 10-8 Auxiliary air regulator 25 - 22 Axle alignment 44-1 - replacing 40 - 19 Body paint colors 66 - 22 Body repair, checking dimensions 50 - 03 - front section damage 50-1 - rear section damage 53-1 - side panels fender damage 53-5 - special tools materials 50 - 01 - welding galvanized metal 50 - 05 Body side moulding 66-1 Brake booster, removing 47-5...