Adjusting Throttle Pressure Cable
1. Detach cable at trans, lever.
2. Adjust lever with adjusting bolt A after loosening clamping bolt B so that cable can be attached without tension or free play.
Caution
Note
Ball socket of cable must be screwed on threads approx. 6 mm (1/4 in.).
When cable is adjusted correctly, trans, lever travel will be approx. 33 mm (1 5/16 in.) as accelerator pedal is depressed from idle to full throttle (not kickdown).
If clamping bolt_B is loosened for adjustments, under no circumstances should bolt be tightened against stop inside transmission (damages operating lever). Use second wrench.
A - adjusting bolt B - clamping bolt
CHECKING NEUTRAL/PARK STARTING SWITCH
Starter should only operate in P or N positions with properly adjusted switch.
ADJUSTING NEUTRAL/PARK STARTING SWITCH
1. Move selector lever to position N.
2. Loosen adjusting screw.
3. Insert 4 mm dia. pin from US 8030 tool set through drive dog into locating hole in case,
REMOVING NEUTRAL/PARK STARTING SWITCH
1. Place selector lever in N position.
2. Disconnect electrical plug.
3. Remove clamping bolt 3 and pull operating lever J. (with attached driving dog) off shaft 5.
4. Remove switch mounting bolts and withdraw switch.
INSTALLING NEUTRAL/PARK STARTING SWITCH
1. Install switch and mounting bolts for same.
2. Place operating lever 1 (with attached driving dog) onto shaft 5.
3. Insert lugs of driving dog into switch.
4. insert clamping bolt_3 into operating lever 1 and tighten nut.
5, Connect electrical plug.
6. Adjust switch.
1 = operating lever
2 = adjusting screw
3 = clamping bolt
4 = locating pin (from US 8030 tool set)
4. Tighten adjusting screw. Remove locating pin.
5. Check whether engine can be started with selector lever in N or P positions.
Post a comment