Checking Dimension E
1. Install drive pinion with measured shims S3 and S4. Bolt end plate and rotate drive pinion in both directions about 20 full revolutions by hand, so that both tapered roller bearings will be preloaded by the rotation and can settle. 2. Apply universal gage and check distance. 3. If shims have been selected correctly, the dial gage read counterclockwise should display the value of deviation r inscribed on the ring gear to a tolerance of
Limitedslip differential dismantling and assembling locking ratio 40
Apply a film of Loctite 262 and tighten with 38 Nm The limited-slip differential for the 944 turbo S has reinforced 2.5 mm thick inner plates 944 turbo only 2.0 mm thick . The two thrust rings are each remachined by 0.5 mm in order to provide the same plate package thickness dimension B . Apart from this, the 944 turbo S differential shafts are molybdenum-coated.
Steering
Technical Data Tightening Inspection and installation work on the rack and pinion power steering 48-1 Front hood cable - Lower trim panel - removal and installation 63-1 Spoiler and bumper - removal and installation 63-3 Spoiler and bumper - removal and installation USA 63-9 Rocker panel covers - removing and installing 66-1 Rear apron spoiler - removing and installing 66-2 Finishes available, 1986 models Turbo emblem - Headlight cleaner spray jets - aiming 92-1 Headlights - Fog lights - aiming...
speed manual transmission 016 R for 944 turbo S
Codes and date of mfg of transmission Example AOR 15 02 Apart from a few deviations, transmission 016 R, code AOR, is identical to the turbo transmission 016 R, code 5R, with regard to construction and repair. The most significant deviations are - transmission-oil cooling as standard - limited slip differential as standard with reinforced inner plates and molybdenum-coated differential - gearwheels for first and second gear on the drive shaft are blasted for increased strength
Modified tightening torques for engine
Modified tightening torques for engine REMOVING AND INSTALLING ENGINE TOOLS Used together with a shop hoist, e.g. Bi1 stein K750 H. If necessary, connect engine suspension fixture and shop hoist with standard spring-loaded hooks load capacity 650 kg . REMOVING AND INSTALLING ENGINE MANUAL TRANSMISSION Engine is removed from below. Clutch housing remains on engine. 1. Set up lifting platform and lift car on jacking points. 2. Place protective covers on fenders. 3. Loosen and remove front wheels....